Okai Error Code 09E

"Throttle failure - Check throttle connector, replace throttle"

If your Okai-Electisan vehicle is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Previous Error Code: Okai Error Code 08E - Next Error Code: Okai Error Code 10E

Cause

Error code 09E indicates a problem with the throttle control system. This could be due to:

• Open circuit: The wire connecting the throttle to the ECU might be broken or disconnected.
• Short circuit: The throttle signal wire or the power wire might be shorted to ground or to each other.
• Damaged throttle: The throttle itself might be faulty.

Fix

• Check throttle wiring: Inspect the wires connecting the throttle to the ECU for any signs of damage, breaks, or loose connections.
• Check for shorts: Make sure the throttle signal wire and the power wire are not shorted to ground or to each other.
• Replace throttle: If the wiring is in good condition, the throttle itself might be faulty and need replacement.