Ninebot ESX Error Code 28: Difference between revisions
Jump to navigation
Jump to search
(Created page with "thumb|center|200px|Error 28 on a Ninebot ESX. "Motor MOS driver upper Bridge is short circuited, Please check the Control Board" ==Cause== =...") |
(→Fix) |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
"Motor MOS driver upper Bridge is short circuited, Please check the Control Board" | "Motor MOS driver upper Bridge is short circuited, Please check the Control Board" | ||
{{Ninebot ESX Error Code SEO|28}} | |||
==Cause== | ==Cause== | ||
This error seems to be caused by a hardware fault described in the error code. | |||
==Fix== | ==Fix== | ||
Unless you are skilled in component-level repair, the best fix is to just [[Replace Ninebot ESX ESC|replace the controller]]. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] | ||
Latest revision as of 17:47, 23 August 2024
"Motor MOS driver upper Bridge is short circuited, Please check the Control Board"
If your Segway Ninebot ESX(ES1, ES2, ES3, or ES4) or Segway SNSC (1.0 or 1.1) is beeping or has a red wrench icon and flashes this code, read below.
If you clicked the wrong error code, go back to the Error Code Index.
Previous Error Code: Ninebot ESX Error Code 27 - Next Error Code: Ninebot ESX Error Code 29
Cause
This error seems to be caused by a hardware fault described in the error code.
Fix
Unless you are skilled in component-level repair, the best fix is to just replace the controller.