Administrators, Swags, Bureaucrats, Administrators
2,932
edits
STLink Ninebot Max G30 BMS: Difference between revisions
m
Joeybab3 moved page STLink Ninebot Max BMS to STLink Ninebot Max G30 BMS
(Created page with "In the case of a bricked BMS/battery, STLinking can save the battery from needing to be replaced in some instances. For this process you will need: * Windows computer * STL...") |
m (Joeybab3 moved page STLink Ninebot Max BMS to STLink Ninebot Max G30 BMS) |
||
| (9 intermediate revisions by the same user not shown) | |||
| Line 14: | Line 14: | ||
If you short a battery line you could end up blowing up your STLink, Computer, and more or even causing a fire. | If you short a battery line you could end up blowing up your STLink, Computer, and more or even causing a fire. | ||
This process can also be used to remove downgraded-protected rental/iot firmware if you are returning your fleet vehicle to on-demand use rather than a rental. | |||
==Accessing the Debug Pins== | ==Accessing the Debug Pins== | ||
| Line 23: | Line 25: | ||
[[File: NinebotMaxBottomScrewLocations.jpg|thumb|center|400px|The locations of the 18 screws.]] | [[File: NinebotMaxBottomScrewLocations.jpg|thumb|center|400px|The locations of the 18 screws.]] | ||
Using an M4 Allen/Hex wrench or bit, remove the | Using an M4 Allen/Hex wrench or bit, remove the ten screws holding the battery in place. | ||
[[File: NinebotMaxESCLocations.jpg|thumb|center|400px|The ESC after being removed.]] | [[File: NinebotMaxESCLocations.jpg|thumb|center|400px|The ESC after being removed.]] | ||
| Line 31: | Line 33: | ||
You may need to scrape more rubber potting compound away from some of the connectors in order to unplug them. | You may need to scrape more rubber potting compound away from some of the connectors in order to unplug them. | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]] | ===Battery Disassembly=== | ||
9 Phillips head screws hold the top cover in place. | |||
These are EXTREMELY easy to strip so take care. | |||
[[File:NinebotMaxBatteryExternalScrews.jpg|center|thumb|400px|These 9 screws hold the top in place.]] | |||
Under the white rubbery spots on the battery, there are 8 more aluminum Phillips head screws. | |||
[[File:NinebotMaxBatteryInternalScrews.jpg|thumb|center|400px|The screws may get stripped if you do not first remove the white potting rubber.]] | |||
==STLink BMS/Battery== | |||
{{Ninebot Max STLink BMS Flash Procedure}} | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: STLink]] | |||